Changing the PIN

Changing the PIN is explained on the back of the black card that you were left after installation. If you do not have this, you can download a copy below. 

PIN Change Procedure:

1. 1. Turn ignition on (do not start the engine).
   2. Enter code.
   3. Double flash of indication lamp (or audible tone).
   4. Foot down on accelerator and hold down (or hold main beam flash on some vehicles, mainly JLR).
   5. Enter code again.
   6. 1 flash every 3 seconds of indication lamp (or audible tone).
   7. Enter new code.
   8. 3 flashes of indication lamp (or audible tone).
   9. Enter new code again.
   10. 2 Flashes of indication lamp (or audible tone).
   11. Release accelerator.
   12. Turn the ignition off.
   13. Wait your usual rearm time (5 to 30 seconds). 
   14. PIN Changed. 

JAGUAR LAND ROVER VEHICLES

Please note:

2017 Models onwards with the black illuminated cruise control buttons, where the instructions call for the accelerator to be pressed use the main beam flash instead. This WILL have been explained and shown to you after the installation.

This is also the same for the following:

PORSCHE AND VW VEHICLES

• • Panamera 2010 to 2016
  • Boxster and Cayman 2012 to 2023
  • Cayenne 2010 to 2018
  • Touareg 2011 to 2018

Vehicle list is not exhaustive.