There’s a description on how to do this in the instruction booklet with the black card that you WERE given on completion of the installation.
Remember – If the vehicle exceeds 30mph for 15 minutes it will automatically exit valet mode. This is more than fine for airport parking and general servicing. We recommend that should your vehicle require a prolonged road test that you change the code to a simple code for the dealership, then change it back to your normal code on completion.
Where possible, always use service mode.
Entering Service Mode
Autowatch Ghost Immobiliser 2 – How to Enter Service Mode
Proceed as below:
- Disarm the system using your PIN number or mobile app.
- Drive to, and park up at the dealership, airport, valeter’s etc
- Leaving the engine running, turn the app completely off (if using) then press your service button 5 times (drivers window switch, accelerator pedal etc 5 times), this is often written in the front page of the instruction booklet and WILL have been told to you on completion of the installation.
- The usual indication lamp in the dash will flash back at you 5 times to confirm valet mode has been entered.
- Turn the ignition off.
- The vehicle will now start and drive without the PIN code.
Exiting Service Mode
Autowatch Ghost Immobiliser 2 – How to Exit Service Mode
Proceed as below:
- Turn the ignition on.
- Enter your code manually.
- Indication lamp will flash twice.
- Service mode has exited.
- Normal operation is resumed when you turn the ignition off.
Service Button
The Service Button WILL have been shown to you on hand over after the installation.
If you can not remember your Service Button see this article.

